Change UART to USB in an existing device!
New DB9-USB connectors from FTDI enable to use a USB port in devices with UART interface without necessity of a PCB redesign.
By simple using of new DB9 USB connectors instead of original DB9 UART
connectors, you can achieve virtually immediately a USB connectivity of your
existing devices. If you from any reasons don´t wish to redesign a PCB, then
these connectors are ideally suitable for you. Connectors DB9 USB contain a
complete USB/UART converter circuit in their bode. So far these connectors were
available in the RS232 logic levels version. Novelty from company FTDI are 4 new
types supporting also 3.3V and 5V logic levels - DB9-USB-D3 and DB9-USB-D5, with
a USB male or female connector.
Advantages / Features:
- complete USB interface in a DB9 sized connector
- available in versions with RS232, 5V and 3.3V logic levels
- transfer rate up to 1Mbaud(RS232) and 3Mbaud(3.3 and 5V version)
- temperature range -40 to +85°C
- extensive customer support from FTDI
DB9 USB family now contains 6 types for all 3 the most common logic levels,
in a version with Male and Female USB connector. New connectors offer the same
utilization comfort like other USB
products from FTDI,
DB9_USB datasheet and in
the AN_149 application note. Free available drivers enable to use DB9 USB
connectors as a Virtual COM Port (VCP).
Gain a free sample:
Describe us an application in which
you´d like to use these new connectors. We will select 20 of you and we´ll
provide you with a free sample. You can send us a description of your aplication
at marketing@soselectronic.com.
201112060829.12.2011ComponentsSOS electronic s.r.o.