Measure SMT components by only one hand
With multimeters VA 503 and VA 505B you don´t have to catch the SMT components
on the table anymore! Speed and comfort of measurment with these multimeters
will probably amaze you.
Measuring of resistance, capacity, diode and
conductivity test – those are the tasks, which SMT tweezers handle with
easiness. Naturally, all this can be measured also with a usual multimeter, but
with one condition – usually you´ll need both hands for it and even so small SMT
components have a tendency to jump out of measuring tips. At this process there
is also an increased risk of damage to their sensitive soldering pads.
Advantages/Features:
- SMD measuring tweezers
- measuring of resistance and
capacity
- measuring of capacity up to 60 000uF (VA 505B) 4.measuring of diodes
(@1ma) 5.conductivivty test (under 30Ohm) 6.automatic component recognizing (VA
505B) 7.manual and automatic range selection (VA 505B) 8.3999 / 5999 max.
display value 9.low battery indication
VA 503 and VA 505B SMT measurinlow battery indication
VA 503 and VA 505B SMT measuring tweezers
eliminate all these nuisances. You only need one hand for measuring and
measuring tips are fixed against side shift, thus a measured component
practically cannot slip out of tweezers. From the principle of tweezers also one
pleasant feature results – you can use the measuring tweezers also like a “usual
tweezers”, i.e. you can use it to relocate a measured component to various
organizers, right after the measurement. Measuring tips are made of quality
non-magnetic material.
From a user point of view, the main difference between VA
503 and VA 505B is, that the VA 505B can measure also in an automatic mode, when
the device automatically chooses not only a measuring range but even recognizes
a measured component type (R,C or Diode). VA 505B is also able to measure even
very high capacitancies – up to 60mF (60 000uF). VA 503 has a maximum display
value of 3999 and VA 505B – 5999. A relatively high resolution of both devices
makes them suitable also for sorting of components – for example when selecting
more capacitors or resistors with the same value. In this case, when we don´t
need an absolute accuracy, but mainly a comparison of components values, we can
relatively very accurately select components with the same values – for example
for usage in various filters or resistive dividers. Measuring of diodes is at
1mA and a 2.8V open circuit voltage, what enables to measure also all kinds of
usual LED diodes. Devices also feature an auto power-off function. Detailed
information will provide you the
VA503_505 datasheet.
20111228102.2.2012Test & measurementSOS electronic s.r.o.